2 x 2 Inches Red Heavy Wall Heat Shrink, Adhesive Lined, 3 to 1 Shrink Ratio

2" Heavy Wall  Heat Shrink
Adhesive Lined
RED
Crosslinked Polyolefin Heat Shrink
Cut piece 2" Length

• Impact, abrasion, corrosion, and chemical resistant; suitable for submersion and direct burial

Features:

• Seals out water and dirt
• High 3 to 1 shrink ratio
• Meets UL 486D, CSA C22.2 198.2, ANSI C119-1, Western Underground Guide 2.4, 2.5, ICEA and NEMA insulation thickness requirements, DNV Type approval
• Continuous operating temperature: -55°C to 110°C
• Shrink temperature: 120°C
• 600V, 90°C continuous use

Applications:

• Electrical/Utility/Industrial
• St rain relief and mechanical protection
• Insulation of primary low voltage cables

-55°C to 110°C

Sizes

Select a size which will shrink snugly over the component to be covered.  Match your component diameter with the 
Recovered Inside Diameter (d) for the best fit.  Restricted recovery will result in lower wall thickness.

HSREDHD-2
D: 2 in. (50.8mm)
d: 0.63 in. (16mm)
w: 0.16 in. (4.1mm)

Physical Property	Test Method	Typical Performance
Tensile Strength	ASTM D412, ISO 37	2100 psi (14.5 MPa)
Elongation	ASTM D412, ISO 37	600%
Elongation after heat aging (168 hours at 175°C)	ASTM D2671, ISO 37	500% (250%)
Longitudinal change on recovery	ASTM D2671	+1%, -10%
Specific Gravity	ASTM D792	1.1
Heat shock (4 hours at 255°C)	ASTM D2671	No cracking or flowing
Low temperature flexibility (4 hours at -55°C)	ASTM D2671	No cracking or splitting
Hardness (Shore D)	ASTM D2240	50D
Oxygen Index	ASTM D2863	27.00
Flammability	ASTM D2671	Flame Retardant
Electrical Property
Dielectric Strength	ASTM D149	500 V/Mil (20kV/mm)
Dielectric Voltage Withstand (2500V, 60Hz, 1 min.)	UL 486D	No breakdown, 24kV-1 Min. 15kV-4 hrs.
Volume Resistivity	ASTM D257	1016 ohm-cm
Chemical Property
Fluid Resistance	MIL-DTL- 23053/15	Good to excellent
Copper Corrosion	ASTM D2671	No Corrosion
Water Absorption	ASTM D570	0.2%
Fungus Resistance	ASTM G21	No growth
Adhesive Property
Adhesive softening point	ASTM E28	92°C +/- 5°C
Adhesive peel strength (300mm/min at 23°C)   - to steel, aluminum, P.E.   - to PVC	ASTM D1000 ASTM D1000	35 pli 20 pli
Adhesive lap shear (1in./min at 23°C)	ASTM D1002	125 psi (0.875 MPa)
Adhesive Blocking (30°C)	ASTM D1146	No blocking
Adhesive water absorption	ASTM D570	less than 0.3%
Water penetration	STM 706	No penetration after 236 hrs of continuous immersion